Glow-in-the-dark PLA Settings for Markforged Onyx Pro
Recommended slicer settings for printing Glow-in-the-dark PLA on the Markforged Onyx Pro (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Non compatiblebeginner
Non compatible
The max bed temperature of 0°C is below the recommended 50°C for Glow-in-the-dark PLA. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 195-225°C |
| Printer Max Nozzle | 280°C |
| Filament Bed Requirement | 50-60°C |
| Printer Max Bed | N/A |
Que faire à la place
- Your printer's bed maxes out at 0°C, but Glow-in-the-dark PLA needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged Onyx Pro — PLA, PETG, and ABS are good options.
- If you need Glow-in-the-dark PLA specifically, you'll need a printer with a hotend capable of 195°C+ nozzle.
Glow-in-the-dark PLA Requirements
Glow-in-the-dark PLA Properties
| Nozzle Range | 195-225°C |
| Bed Range | 50-60°C |
| Speed Range | 30-50 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged Onyx Pro Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 280°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
Glow-in-the-dark PLA en un coup d'œil
Points forts
- Charges in light and glows in the dark
- Fun for decorative and safety items
- Prints like standard PLA
Points faibles
- Phosphorescent particles are abrasive — hardened nozzle required
- Limited to green/blue glow colors
- Glow fades over minutes without recharging
- Surface finish is slightly grainy
Tu veux des réglages IA personnalisés ?
Décris ton setup exact et ce que tu imprimes. L'expert IA de 3DSearch génère des réglages de slicer sur mesure pour ton Markforged Onyx Pro avec Glow-in-the-dark PLA en quelques secondes.
Essayer 3DSearch →Sources : Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valeurs calculées à partir des spécifications du filament et des limites matérielles de l'imprimante.