Breakaway Support Settings for Markforged Onyx Pro
Recommended slicer settings for printing Breakaway Support on the Markforged Onyx Pro (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Non compatiblebeginner
Non compatible
The max bed temperature of 0°C is below the recommended 50°C for Breakaway Support. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 210-240°C |
| Printer Max Nozzle | 280°C |
| Filament Bed Requirement | 50-70°C |
| Printer Max Bed | N/A |
Que faire à la place
- Your printer's bed maxes out at 0°C, but Breakaway Support needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged Onyx Pro — PLA, PETG, and ABS are good options.
- If you need Breakaway Support specifically, you'll need a printer with a hotend capable of 210°C+ nozzle.
Breakaway Support Requirements
Breakaway Support Properties
| Nozzle Range | 210-240°C |
| Bed Range | 50-70°C |
| Speed Range | 30-50 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged Onyx Pro Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 280°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
Breakaway Support en un coup d'œil
Points forts
- Snaps off cleanly without solvents
- Fast removal — no dissolving wait time
- Works with most build materials
- No special post-processing needed
Points faibles
- Leaves rougher surface than dissolved supports
- Requires accessible support geometry
- Not suitable for internal cavities
- May need pliers for tight areas
Tu veux des réglages IA personnalisés ?
Décris ton setup exact et ce que tu imprimes. L'expert IA de 3DSearch génère des réglages de slicer sur mesure pour ton Markforged Onyx Pro avec Breakaway Support en quelques secondes.
Essayer 3DSearch →Sources : Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valeurs calculées à partir des spécifications du filament et des limites matérielles de l'imprimante.