PLA+ Settings for Markforged FX10
Recommended slicer settings for printing PLA+ on the Markforged FX10 (400 x 330 x 315 mm build volume, 250 mm/s max speed, direct drive extruder).
Non compatiblebeginner
Non compatible
The max bed temperature of 0°C is below the recommended 50°C for PLA+. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 200-230°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 50-70°C |
| Printer Max Bed | N/A |
Que faire à la place
- Your printer's bed maxes out at 0°C, but PLA+ needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged FX10 — PLA, PETG, and ABS are good options.
- If you need PLA+ specifically, you'll need a printer with a hotend capable of 200°C+ nozzle.
PLA+ Requirements
PLA+ Properties
| Nozzle Range | 200-230°C |
| Bed Range | 50-70°C |
| Speed Range | 40-60 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged FX10 Specs
| Build Volume | 400 x 330 x 315 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PLA+ en un coup d'œil
Points forts
- Up to 4x better impact resistance than PLA
- Higher heat tolerance (70-80C vs 55-60C for PLA)
- Better layer adhesion
- Less brittle than standard PLA
- Same ease of printing as PLA
Points faibles
- Not a standardized spec (varies by brand)
- Slightly more expensive than PLA
- Some brands offer little improvement over regular PLA
- Still not suitable for high-heat or heavy-load applications
Tu veux des réglages IA personnalisés ?
Décris ton setup exact et ce que tu imprimes. L'expert IA de 3DSearch génère des réglages de slicer sur mesure pour ton Markforged FX10 avec PLA+ en quelques secondes.
Essayer 3DSearch →Sources : Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valeurs calculées à partir des spécifications du filament et des limites matérielles de l'imprimante.