PA6 Settings for Markforged FX10
Recommended slicer settings for printing PA6 on the Markforged FX10 (400 x 330 x 315 mm build volume, 250 mm/s max speed, direct drive extruder).
Non compatibleadvanced
Non compatible
The max bed temperature of 0°C is below the recommended 80°C for PA6. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 240-270°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 80-100°C |
| Printer Max Bed | N/A |
Que faire à la place
- Your printer's bed maxes out at 0°C, but PA6 needs at least 80°C for reliable adhesion.
- Try a compatible filament for your Markforged FX10 — PLA, PETG, and ABS are good options.
- If you need PA6 specifically, you'll need a printer with a hotend capable of 240°C+ nozzle.
PA6 Requirements
PA6 Properties
| Nozzle Range | 240-270°C |
| Bed Range | 80-100°C |
| Speed Range | 30-50 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 85°C / 12h |
Markforged FX10 Specs
| Build Volume | 400 x 330 x 315 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PA6 en un coup d'œil
Points forts
- Strongest common nylon variant
- Exceptional wear and fatigue resistance
- Good chemical resistance
- Excellent for gears, bearings, hinges
Points faibles
- Extremely hygroscopic — must dry extensively
- Warps aggressively without enclosure
- Difficult bed adhesion
- Shrinks significantly during cooling
Tu veux des réglages IA personnalisés ?
Décris ton setup exact et ce que tu imprimes. L'expert IA de 3DSearch génère des réglages de slicer sur mesure pour ton Markforged FX10 avec PA6 en quelques secondes.
Essayer 3DSearch →Sources : Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valeurs calculées à partir des spécifications du filament et des limites matérielles de l'imprimante.