Glass-fiber PETG Settings for Markforged FX10
Recommended slicer settings for printing Glass-fiber PETG on the Markforged FX10 (400 x 330 x 315 mm build volume, 250 mm/s max speed, direct drive extruder).
Non compatibleintermediate
Non compatible
The max bed temperature of 0°C is below the recommended 80°C for Glass-fiber PETG. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 235-260°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 80-95°C |
| Printer Max Bed | N/A |
Que faire à la place
- Your printer's bed maxes out at 0°C, but Glass-fiber PETG needs at least 80°C for reliable adhesion.
- Try a compatible filament for your Markforged FX10 — PLA, PETG, and ABS are good options.
- If you need Glass-fiber PETG specifically, you'll need a printer with a hotend capable of 235°C+ nozzle.
Glass-fiber PETG Requirements
Glass-fiber PETG Properties
| Nozzle Range | 235-260°C |
| Bed Range | 80-95°C |
| Speed Range | 30-50 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 65°C / 7h |
Markforged FX10 Specs
| Build Volume | 400 x 330 x 315 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
Glass-fiber PETG en un coup d'œil
Points forts
- Much stiffer than standard PETG
- Better heat resistance than plain PETG
- Good dimensional stability
- Less expensive than carbon fiber composites
Points faibles
- Hardened steel nozzle required
- Increased brittleness vs standard PETG
- Use 0.5mm+ nozzle to prevent clogging
- Rougher surface finish
Tu veux des réglages IA personnalisés ?
Décris ton setup exact et ce que tu imprimes. L'expert IA de 3DSearch génère des réglages de slicer sur mesure pour ton Markforged FX10 avec Glass-fiber PETG en quelques secondes.
Essayer 3DSearch →Sources : Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valeurs calculées à partir des spécifications du filament et des limites matérielles de l'imprimante.