PETG-CF Settings for Monoprice MP Select Mini
Recommended slicer settings for printing PETG-CF on the Monoprice MP Select Mini (120 x 120 x 120 mm build volume, 55 mm/s max speed, Bowden extruder).
Nicht kompatibelintermediate
Nicht kompatibel
The max bed temperature of 60°C is below the recommended 70°C for PETG-CF. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 230-260°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 70-80°C |
| Printer Max Bed | 60°C |
Was du stattdessen tun kannst
- Your printer's bed maxes out at 60°C, but PETG-CF needs at least 70°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Select Mini — PLA, PETG, and ABS are good options.
- If you need PETG-CF specifically, you'll need a printer with a hotend capable of 230°C+ nozzle.
PETG-CF Requirements
PETG-CF Properties
| Nozzle Range | 230-260°C |
| Bed Range | 70-80°C |
| Speed Range | 30-50 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 65°C / 8h |
Monoprice MP Select Mini Specs
| Build Volume | 120 x 120 x 120 mm |
| Max Speed | 55 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Bowden |
PETG-CF auf einen Blick
Stärken
- Significantly stiffer than standard PETG
- Professional matte surface finish
- Reduced warping compared to plain PETG
- Good chemical and moisture resistance
- Excellent for functional brackets, jigs, and fixtures
Schwächen
- Requires hardened steel nozzle (carbon fibers destroy brass)
- More brittle than standard PETG (reduced flexibility)
- Must use 0.5mm+ nozzle to prevent clogging
- Slower print speeds required than standard PETG
- Higher cost than plain PETG ($30-45/kg)
Möchtest du personalisierte KI-Einstellungen?
Beschreibe dein genaues Setup und was du druckst. 3DSearch's KI-Experte erzeugt in Sekunden individuelle Slicer-Einstellungen für deinen Monoprice MP Select Mini mit PETG-CF.
3DSearch ausprobieren →Quellen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Werte berechnet aus Filament-Spezifikationen und Drucker-Hardware-Limits.