PHA Settings for Markforged FX10
Recommended slicer settings for printing PHA on the Markforged FX10 (400 x 330 x 315 mm build volume, 250 mm/s max speed, direct drive extruder).
غير متوافقbeginner
غير متوافق
The max bed temperature of 0°C is below the recommended 40°C for PHA. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 175-200°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 40-60°C |
| Printer Max Bed | N/A |
ما الذي يجب فعله بدلاً من ذلك
- Your printer's bed maxes out at 0°C, but PHA needs at least 40°C for reliable adhesion.
- Try a compatible filament for your Markforged FX10 — PLA, PETG, and ABS are good options.
- If you need PHA specifically, you'll need a printer with a hotend capable of 175°C+ nozzle.
PHA Requirements
PHA Properties
| Nozzle Range | 175-200°C |
| Bed Range | 40-60°C |
| Speed Range | 25-45 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged FX10 Specs
| Build Volume | 400 x 330 x 315 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PHA في لمحة
نقاط القوة
- Fully biodegradable in soil and marine environments
- Renewable bioplastic from bacterial fermentation
- Non-toxic and biocompatible
- Easier to print than PLA in some cases
نقاط الضعف
- Lower heat resistance than PLA (~55°C)
- More expensive than PLA
- Limited availability and color options
- Slower degradation rate than marketed
تريد إعدادات AI مخصصة؟
صِف إعدادك الدقيق وما تطبعه. يُنشئ خبير AI في 3DSearch إعدادات تقطيع مخصصة لطابعتك Markforged FX10 مع PHA خلال ثوانٍ.
جرّب 3DSearch →المصادر: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. تم حساب القيم من مواصفات الفيلامنت وحدود عتاد الطابعة.