POM Settings for UltiMaker S3
Recommended slicer settings for printing POM on the UltiMaker S3 (230 x 190 x 200 mm build volume, 300 mm/s max speed, direct drive extruder).
Uyumlu Değiladvanced
Uyumlu Değil
The max bed temperature of 85°C is below the recommended 100°C for POM. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 200-220°C |
| Printer Max Nozzle | 280°C |
| Filament Bed Requirement | 100-130°C |
| Printer Max Bed | 85°C |
Bunun yerine yapılması gerekenler
- Your printer's bed maxes out at 85°C, but POM needs at least 100°C for reliable adhesion.
- Try a compatible filament for your UltiMaker S3 — PLA, PETG, and ABS are good options.
- If you need POM specifically, you'll need a printer with a hotend capable of 200°C+ nozzle and 100°C+ heated bed.
POM Requirements
POM Properties
| Nozzle Range | 200-220°C |
| Bed Range | 100-130°C |
| Speed Range | 20-40 mm/s |
| Difficulty | advanced |
| Enclosure | Not needed |
| Drying | 60°C / 6h |
UltiMaker S3 Specs
| Build Volume | 230 x 190 x 200 mm |
| Max Speed | 300 mm/s |
| Max Nozzle Temp | 280°C |
| Max Bed Temp | 85°C |
| Extruder | Direct Drive |
POM Bir Bakışta
Güçlü Yönleri
- Lowest friction of any printable plastic
- Replaces machined Delrin/Acetal parts
- Self-lubricating — ideal for gears and bearings
- Excellent fatigue resistance
Zayıf Yönleri
- Extremely difficult bed adhesion
- Requires POM-specific build surface or tape
- Emits formaldehyde fumes — ventilation required
- Very few printers handle it well
Kişiselleştirilmiş yapay zeka ayarları ister misin?
Tam kurulumunu ve ne yazdırdığını açıkla. 3DSearch'ün yapay zeka uzmanı saniyeler içinde POM ile UltiMaker S3 için özel slicer ayarları oluşturuyor.
3DSearch'ü dene →Kaynaklar: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Değerler filament belirtimleri ve yazıcı donanım sınırlarından hesaplanmıştır.