PEEK Settings for UltiMaker S3
Recommended slicer settings for printing PEEK on the UltiMaker S3 (230 x 190 x 200 mm build volume, 300 mm/s max speed, direct drive extruder).
Uyumlu Değil
The UltiMaker S3 has a max nozzle temperature of 280°C, which may be below the minimum recommended 370°C for PEEK. Printing may be possible at the lower end of the temperature range but results may be suboptimal. The max bed temperature of 85°C is below the recommended 130°C for PEEK. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 370-420°C |
| Printer Max Nozzle | 280°C |
| Filament Bed Requirement | 130-160°C |
| Printer Max Bed | 85°C |
Bunun yerine yapılması gerekenler
- Your printer's hotend maxes out at 280°C, but PEEK needs at least 370°C. No amount of tuning can overcome this hardware limitation.
- Your printer's bed maxes out at 85°C, but PEEK needs at least 130°C for reliable adhesion.
- Try a compatible filament for your UltiMaker S3 — PLA, PETG, and ABS are good options.
- If you need PEEK specifically, you'll need a printer with an all-metal hotend rated for 370°C+ nozzle and 130°C+ heated bed.
PEEK Requirements
PEEK Properties
| Nozzle Range | 370-420°C |
| Bed Range | 130-160°C |
| Speed Range | 15-30 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 150°C / 6h |
UltiMaker S3 Specs
| Build Volume | 230 x 190 x 200 mm |
| Max Speed | 300 mm/s |
| Max Nozzle Temp | 280°C |
| Max Bed Temp | 85°C |
| Extruder | Direct Drive |
PEEK Bir Bakışta
Güçlü Yönleri
- Heat resistance up to 250°C continuous
- Exceptional chemical resistance
- Aerospace and medical grade material
- Biocompatible grades available
Zayıf Yönleri
- Requires specialized printer (400°C+ hotend, heated enclosure)
- Extremely expensive (~$300-700/kg)
- Needs heated chamber at 120°C+
- Cannot be printed on consumer-grade machines
Kişiselleştirilmiş yapay zeka ayarları ister misin?
Tam kurulumunu ve ne yazdırdığını açıkla. 3DSearch'ün yapay zeka uzmanı saniyeler içinde PEEK ile UltiMaker S3 için özel slicer ayarları oluşturuyor.
3DSearch'ü dene →Kaynaklar: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Değerler filament belirtimleri ve yazıcı donanım sınırlarından hesaplanmıştır.