PEEK Settings for Anycubic Kobra S1
Recommended slicer settings for printing PEEK on the Anycubic Kobra S1 (250 x 250 x 250 mm build volume, 600 mm/s max speed, direct drive extruder).
Uyumlu Değil
The Anycubic Kobra S1 has a max nozzle temperature of 320°C, which may be below the minimum recommended 370°C for PEEK. Printing may be possible at the lower end of the temperature range but results may be suboptimal. The max bed temperature of 120°C is below the recommended 130°C for PEEK. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 370-420°C |
| Printer Max Nozzle | 320°C |
| Filament Bed Requirement | 130-160°C |
| Printer Max Bed | 120°C |
Bunun yerine yapılması gerekenler
- Your printer's hotend maxes out at 320°C, but PEEK needs at least 370°C. No amount of tuning can overcome this hardware limitation.
- Your printer's bed maxes out at 120°C, but PEEK needs at least 130°C for reliable adhesion.
- Try a compatible filament for your Anycubic Kobra S1 — PLA, PETG, and ABS are good options.
- If you need PEEK specifically, you'll need a printer with an all-metal hotend rated for 370°C+ nozzle and 130°C+ heated bed.
PEEK Requirements
PEEK Properties
| Nozzle Range | 370-420°C |
| Bed Range | 130-160°C |
| Speed Range | 15-30 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 150°C / 6h |
Anycubic Kobra S1 Specs
| Build Volume | 250 x 250 x 250 mm |
| Max Speed | 600 mm/s |
| Max Nozzle Temp | 320°C |
| Max Bed Temp | 120°C |
| Extruder | Direct Drive |
PEEK Bir Bakışta
Güçlü Yönleri
- Heat resistance up to 250°C continuous
- Exceptional chemical resistance
- Aerospace and medical grade material
- Biocompatible grades available
Zayıf Yönleri
- Requires specialized printer (400°C+ hotend, heated enclosure)
- Extremely expensive (~$300-700/kg)
- Needs heated chamber at 120°C+
- Cannot be printed on consumer-grade machines
Kişiselleştirilmiş yapay zeka ayarları ister misin?
Tam kurulumunu ve ne yazdırdığını açıkla. 3DSearch'ün yapay zeka uzmanı saniyeler içinde PEEK ile Anycubic Kobra S1 için özel slicer ayarları oluşturuyor.
3DSearch'ü dene →Kaynaklar: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Değerler filament belirtimleri ve yazıcı donanım sınırlarından hesaplanmıştır.