Silk PLA Settings for Artillery X4 Pro S1

Temperature Settings

Start with the nozzle at 223°C and the bed at 65°C. If you see poor layer adhesion, increase the nozzle temperature by 5°C increments. If you experience stringing, decrease the nozzle temperature by 5°C. For the first layer, you can increase the bed temperature by 5°C for better adhesion, then let it drop back to 65°C for subsequent layers.

The Silk PLA filament has a recommended nozzle temperature range of 215-230°C and a bed temperature range of 60-70°C. The Artillery X4 Pro S1 supports nozzle temperatures up to 300°C and bed temperatures up to 110°C, which fully covers the recommended range for this filament.

Speed & Quality

The Artillery X4 Pro S1 supports high-speed printing at up to 500 mm/s. For Silk PLA, we recommend 30-50 mm/s for general printing. Start with the lower end for quality-critical prints and increase for draft prints. Always print the first layer at 25-50% of your normal speed for better adhesion.

For quality-critical prints like miniatures or display pieces, reduce the speed to 30 mm/s and use a 0.12-0.16mm layer height. For draft or rapid prototyping, you can push the speed to 50 mm/s with a 0.24-0.28mm layer height. The standard 0.2mm layer height at 40 mm/s provides the best balance of speed and quality for most prints.

Bed Adhesion

Silk PLA uses the same adhesion as regular PLA. A clean PEI sheet is ideal. The shiny finish can make it slightly harder to get a good first layer, so increase bed temperature by 5°C if needed.

Common Issues with Silk PLA on Artillery X4 Pro S1

Here are the most common problems you may encounter when printing Silk PLA on the Artillery X4 Pro S1, along with proven solutions:

• Reduced shine: Print at the hotter end of the range (220-230°C) and use medium speed for maximum sheen
• Brittle prints: Silk PLA is more fragile than regular PLA; not suitable for functional or load-bearing parts
• Poor first layer: Increase bed temperature by 5°C and slow down the first layer speed
• Stringing: Reduce temperature by 5°C and fine-tune retraction

Tips for Best Results

Follow these expert tips to get the best possible prints with Silk PLA on your Artillery X4 Pro S1:

• Print at the hotter end (215-225°C) for maximum metallic sheen and shine
• Medium print speed gives the best surface finish -- too fast reduces the glossy effect
• Lower infill density helps the outer walls look smoother and more reflective
• Silk PLA is purely decorative -- do not use it for functional or load-bearing parts
• Combine with good lighting in your display area to maximize the visual impact of the silk finish

Support Settings

For prints requiring supports with Silk PLA, use tree supports for easier removal and less scarring. Set a 0.15-0.2mm Z-distance between support and model. If you have a dual-extruder setup, consider PVA (for PLA/PETG) or HIPS (for ABS) as dedicated water/solvent-soluble support material.

Silk PLA at a Glance

Artillery X4 Pro S1 Specifications

The Artillery X4 Pro S1 features a 220 x 220 x 250 mm build volume with a maximum print speed of 500 mm/s. It uses a direct drive extruder system, which provides better control over flexible and specialty filaments. The hotend can reach 300°C and the heated bed supports temperatures up to 110°C.