Wood PLA Settings for Artillery M1 Pro S1

Temperature Settings

Start with the nozzle at 195°C and the bed at 50°C. If you see poor layer adhesion, increase the nozzle temperature by 5°C increments. If you experience stringing, decrease the nozzle temperature by 5°C. For the first layer, you can increase the bed temperature by 5°C for better adhesion, then let it drop back to 50°C for subsequent layers.

The Wood PLA filament has a recommended nozzle temperature range of 180-210°C and a bed temperature range of 40-60°C. The Artillery M1 Pro S1 supports nozzle temperatures up to 300°C and bed temperatures up to 110°C, which fully covers the recommended range for this filament.

Speed & Quality

The Artillery M1 Pro S1 supports high-speed printing at up to 500 mm/s. For Wood PLA, we recommend 30-50 mm/s for general printing. Start with the lower end for quality-critical prints and increase for draft prints. Always print the first layer at 25-50% of your normal speed for better adhesion.

For quality-critical prints like miniatures or display pieces, reduce the speed to 30 mm/s and use a 0.12-0.16mm layer height. For draft or rapid prototyping, you can push the speed to 50 mm/s with a 0.24-0.28mm layer height. The standard 0.2mm layer height at 40 mm/s provides the best balance of speed and quality for most prints.

Bed Adhesion

Wood PLA adheres well to PEI sheets and glass beds with glue stick. Same adhesion approach as regular PLA. The wood fibers can make the first layer slightly rougher.

Common Issues with Wood PLA on Artillery M1 Pro S1

Here are the most common problems you may encounter when printing Wood PLA on the Artillery M1 Pro S1, along with proven solutions:

• Nozzle clogging: Use a 0.6mm nozzle and do not leave filament sitting hot in the nozzle (wood chars and blocks it)
• Stringing: Lower temperature and tune retraction; wood PLA tends to ooze at higher temps
• Inconsistent color: This is actually a feature -- temperature variation creates a natural wood grain look
• Rough surface: Print slower for smoother results; sand and stain for a finished wood appearance

Tips for Best Results

Follow these expert tips to get the best possible prints with Wood PLA on your Artillery M1 Pro S1:

• Experiment with temperature to control the wood color: lower temps = lighter, higher temps = darker
• Use a 0.6mm nozzle to prevent clogging from wood particles
• Never leave wood PLA idle in a hot nozzle -- the wood fibers will char and cause a permanent clog
• Finished prints can be sanded and stained just like real wood for stunning results
• Vase mode prints with wood PLA create beautiful, natural-looking decorative pieces

Support Settings

For prints requiring supports with Wood PLA, use tree supports for easier removal and less scarring. Set a 0.15-0.2mm Z-distance between support and model. If you have a dual-extruder setup, consider PVA (for PLA/PETG) or HIPS (for ABS) as dedicated water/solvent-soluble support material.

Wood PLA at a Glance

Artillery M1 Pro S1 Specifications

The Artillery M1 Pro S1 features a 220 x 220 x 250 mm build volume with a maximum print speed of 500 mm/s. It uses a direct drive extruder system, which provides better control over flexible and specialty filaments. The hotend can reach 300°C and the heated bed supports temperatures up to 110°C.