ABS Settings for UltiMaker S3
Recommended slicer settings for printing ABS on the UltiMaker S3 (230 x 190 x 200 mm build volume, 300 mm/s max speed, direct drive extruder).
Несовместимоintermediate
Несовместимо
The max bed temperature of 85°C is below the recommended 95°C for ABS. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 230-260°C |
| Printer Max Nozzle | 280°C |
| Filament Bed Requirement | 95-110°C |
| Printer Max Bed | 85°C |
Что делать вместо этого
- Your printer's bed maxes out at 85°C, but ABS needs at least 95°C for reliable adhesion.
- Try a compatible filament for your UltiMaker S3 — PLA, PETG, and ABS are good options.
- If you need ABS specifically, you'll need a printer with a hotend capable of 230°C+ nozzle.
ABS Requirements
ABS Properties
| Nozzle Range | 230-260°C |
| Bed Range | 95-110°C |
| Speed Range | 30-70 mm/s |
| Difficulty | intermediate |
| Enclosure | Required |
| Drying | 77°C / 4h |
UltiMaker S3 Specs
| Build Volume | 230 x 190 x 200 mm |
| Max Speed | 300 mm/s |
| Max Nozzle Temp | 280°C |
| Max Bed Temp | 85°C |
| Extruder | Direct Drive |
ABS с первого взгляда
Сильные стороны
- Good heat resistance (softens ~105C)
- Good impact resistance
- Can be acetone-smoothed for glossy finish
- Widely used classic engineering plastic
- Good for functional indoor parts
Слабые стороны
- Warps aggressively without enclosure
- Emits styrene fumes (ventilation needed)
- Poor UV resistance (yellows in sunlight)
- Requires high bed temperature
Хочешь персонализированные параметры ИИ?
Опиши свою точную конфигурацию и то, что ты печатаешь. Эксперт ИИ 3DSearch генерирует пользовательские параметры слайсера для твоего UltiMaker S3 с ABS за секунды.
Попробуй 3DSearch →Источники: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Значения рассчитаны на основе спецификаций филамента и ограничений аппаратного обеспечения принтера.