PA6 Settings for Markforged X7
Recommended slicer settings for printing PA6 on the Markforged X7 (330 x 270 x 200 mm build volume, 200 mm/s max speed, direct drive extruder).
Несовместимоadvanced
Несовместимо
The max bed temperature of 0°C is below the recommended 80°C for PA6. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 240-270°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 80-100°C |
| Printer Max Bed | N/A |
Что делать вместо этого
- Your printer's bed maxes out at 0°C, but PA6 needs at least 80°C for reliable adhesion.
- Try a compatible filament for your Markforged X7 — PLA, PETG, and ABS are good options.
- If you need PA6 specifically, you'll need a printer with a hotend capable of 240°C+ nozzle.
PA6 Requirements
PA6 Properties
| Nozzle Range | 240-270°C |
| Bed Range | 80-100°C |
| Speed Range | 30-50 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 85°C / 12h |
Markforged X7 Specs
| Build Volume | 330 x 270 x 200 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PA6 с первого взгляда
Сильные стороны
- Strongest common nylon variant
- Exceptional wear and fatigue resistance
- Good chemical resistance
- Excellent for gears, bearings, hinges
Слабые стороны
- Extremely hygroscopic — must dry extensively
- Warps aggressively without enclosure
- Difficult bed adhesion
- Shrinks significantly during cooling
Хочешь персонализированные параметры ИИ?
Опиши свою точную конфигурацию и то, что ты печатаешь. Эксперт ИИ 3DSearch генерирует пользовательские параметры слайсера для твоего Markforged X7 с PA6 за секунды.
Попробуй 3DSearch →Источники: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Значения рассчитаны на основе спецификаций филамента и ограничений аппаратного обеспечения принтера.