BVOH Settings for Markforged X7
Recommended slicer settings for printing BVOH on the Markforged X7 (330 x 270 x 200 mm build volume, 200 mm/s max speed, direct drive extruder).
Não Compatívelbeginner
Não Compatível
The max bed temperature of 0°C is below the recommended 50°C for BVOH. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 190-220°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 50-60°C |
| Printer Max Bed | N/A |
O que fazer em vez disso
- Your printer's bed maxes out at 0°C, but BVOH needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged X7 — PLA, PETG, and ABS are good options.
- If you need BVOH specifically, you'll need a printer with a hotend capable of 190°C+ nozzle.
BVOH Requirements
BVOH Properties
| Nozzle Range | 190-220°C |
| Bed Range | 50-60°C |
| Speed Range | 20-40 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged X7 Specs
| Build Volume | 330 x 270 x 200 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
BVOH em Primeiro Lugar
Forças
- Water-soluble support material
- Dissolves faster than PVA (2-4 hours)
- Works with wider range of build materials
- Leaves very clean supported surfaces
Fraquezas
- Extremely moisture sensitive — use immediately after opening
- More expensive than PVA
- Must store in sealed dry container
- Limited shelf life once opened
Quer configurações de IA personalizadas?
Descreva sua configuração exata e o que está imprimindo. O especialista em IA do 3DSearch gera configurações personalizadas do slicer para seu Markforged X7 com BVOH em segundos.
Experimente 3DSearch →Fontes: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valores calculados a partir de especificações de filamento e limites de hardware da impressora.