HIPS Settings for UltiMaker S3
Recommended slicer settings for printing HIPS on the UltiMaker S3 (230 x 190 x 200 mm build volume, 300 mm/s max speed, direct drive extruder).
Nicht kompatibelintermediate
Nicht kompatibel
The max bed temperature of 85°C is below the recommended 90°C for HIPS. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 230-245°C |
| Printer Max Nozzle | 280°C |
| Filament Bed Requirement | 90-110°C |
| Printer Max Bed | 85°C |
Was du stattdessen tun kannst
- Your printer's bed maxes out at 85°C, but HIPS needs at least 90°C for reliable adhesion.
- Try a compatible filament for your UltiMaker S3 — PLA, PETG, and ABS are good options.
- If you need HIPS specifically, you'll need a printer with a hotend capable of 230°C+ nozzle.
HIPS Requirements
HIPS Properties
| Nozzle Range | 230-245°C |
| Bed Range | 90-110°C |
| Speed Range | 40-50 mm/s |
| Difficulty | intermediate |
| Enclosure | Required |
| Drying | Not required |
UltiMaker S3 Specs
| Build Volume | 230 x 190 x 200 mm |
| Max Speed | 300 mm/s |
| Max Nozzle Temp | 280°C |
| Max Bed Temp | 85°C |
| Extruder | Direct Drive |
HIPS auf einen Blick
Stärken
- Dissolves in D-Limonene (support material for ABS)
- Much cheaper than PVA ($20-25/kg)
- Low moisture sensitivity
- Can be used as standalone lightweight material
- Easy to paint and post-process
Schwächen
- Requires D-Limonene solvent
- Only pairs well with ABS
- Needs enclosure (same as ABS)
- Less common than PVA for support use
Möchtest du personalisierte KI-Einstellungen?
Beschreibe dein genaues Setup und was du druckst. 3DSearch's KI-Experte erzeugt in Sekunden individuelle Slicer-Einstellungen für deinen UltiMaker S3 mit HIPS.
3DSearch ausprobieren →Quellen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Werte berechnet aus Filament-Spezifikationen und Drucker-Hardware-Limits.