Matte PLA Settings for Markforged X7
Recommended slicer settings for printing Matte PLA on the Markforged X7 (330 x 270 x 200 mm build volume, 200 mm/s max speed, direct drive extruder).
Nicht kompatibelbeginner
Nicht kompatibel
The max bed temperature of 0°C is below the recommended 50°C for Matte PLA. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 195-225°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 50-65°C |
| Printer Max Bed | N/A |
Was du stattdessen tun kannst
- Your printer's bed maxes out at 0°C, but Matte PLA needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged X7 — PLA, PETG, and ABS are good options.
- If you need Matte PLA specifically, you'll need a printer with a hotend capable of 195°C+ nozzle.
Matte PLA Requirements
Matte PLA Properties
| Nozzle Range | 195-225°C |
| Bed Range | 50-65°C |
| Speed Range | 40-60 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged X7 Specs
| Build Volume | 330 x 270 x 200 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
Matte PLA auf einen Blick
Stärken
- Beautiful non-reflective matte surface finish
- Hides layer lines better than standard PLA
- Same ease of printing as PLA
- Available in wide color range
Schwächen
- Slightly weaker than standard PLA
- Surface scratches more visibly
- More expensive than regular PLA
Möchtest du personalisierte KI-Einstellungen?
Beschreibe dein genaues Setup und was du druckst. 3DSearch's KI-Experte erzeugt in Sekunden individuelle Slicer-Einstellungen für deinen Markforged X7 mit Matte PLA.
3DSearch ausprobieren →Quellen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Werte berechnet aus Filament-Spezifikationen und Drucker-Hardware-Limits.