TPU Settings for Voron 0.2

Temperature Settings

Start with the nozzle at 225°C and the bed at 50°C. If you see poor layer adhesion, increase the nozzle temperature by 5°C increments. If you experience stringing, decrease the nozzle temperature by 5°C. For the first layer, you can increase the bed temperature by 5°C for better adhesion, then let it drop back to 50°C for subsequent layers.

The TPU filament has a recommended nozzle temperature range of 210-240°C and a bed temperature range of 40-60°C. The Voron 0.2 supports nozzle temperatures up to 300°C and bed temperatures up to 110°C, which fully covers the recommended range for this filament.

Speed & Quality

The Voron 0.2 supports high-speed printing at up to 300 mm/s. For TPU, we recommend 20-50 mm/s for general printing. Start with the lower end for quality-critical prints and increase for draft prints. Always print the first layer at 25-50% of your normal speed for better adhesion.

For quality-critical prints like miniatures or display pieces, reduce the speed to 20 mm/s and use a 0.12-0.16mm layer height. For draft or rapid prototyping, you can push the speed to 50 mm/s with a 0.24-0.28mm layer height. The standard 0.2mm layer height at 35 mm/s provides the best balance of speed and quality for most prints.

Bed Adhesion

TPU adheres well to most surfaces including PEI sheets, blue painter's tape, and glass with glue stick. Adhesion is rarely an issue with TPU.

Common Issues with TPU on Voron 0.2

Here are the most common problems you may encounter when printing TPU on the Voron 0.2, along with proven solutions:

• Filament jamming: Reduce print speed significantly; check extruder path for gaps where flexible filament can buckle
• Stringing: Reduce temperature, increase travel speed, and reduce retraction distance (less is more with TPU)
• Under-extrusion: Increase flow rate by 5-10% and slow down the print speed
• Grinding filament: Reduce retraction distance and check extruder gear tension

Tips for Best Results

Follow these expert tips to get the best possible prints with TPU on your Voron 0.2:

• Speed is the most critical setting -- printing too fast is the number one cause of TPU failures
• A direct drive extruder is strongly recommended; Bowden setups struggle with flexible filaments
• Minimize retraction (0.5-1mm on direct drive) -- excessive retraction causes jams
• Dry your TPU before every use in humid climates; it is very hygroscopic
• Consider starting with Shore 95A TPU -- it is the easiest flexible filament to print

Support Settings

For prints requiring supports with TPU, use tree supports for easier removal and less scarring. Set a 0.15-0.2mm Z-distance between support and model. If you have a dual-extruder setup, consider PVA (for PLA/PETG) or HIPS (for ABS) as dedicated water/solvent-soluble support material.

TPU at a Glance

Voron 0.2 Specifications

The Voron 0.2 features a 120 x 120 x 120 mm build volume with a maximum print speed of 300 mm/s. It uses a direct drive extruder system, which provides better control over flexible and specialty filaments. The hotend can reach 300°C and the heated bed supports temperatures up to 110°C.