Spool holder Anycubic Kobra S1

This is a sturdy and practical spool holder. This design lets you clearly see your spool, and you can mount the spool either at the front or back! ✔ No supports needed – prints easily and cleanly ✔ Simple installation – just a few screws required ✔ Customizable mounting – place your spool where it suits you best Printing & Assembly: I've used: 0.20mm layer height, 15% grid infill Requires three M3 screws (~15mm long) for mounting An M3 screw secures the shaft (I used the original screw from the back) I’ve put a lot of time into designing this and plan to improve it further—perhaps adding bearings in the future. While it’s not mandatory, a small contribution would be greatly appreciated! https://buymeacoffee.com/michimess