120mm Fan Dryer Housing for Air drying sleeves

I was originally not going to share this thing due to potential dangers if used improperly... but I decided to just upload and give a warning instead. **Warning: Make sure no water will drip onto the fan, I strongly urge you to pat the outside of the sleeve with a microfiber cloth and hang dry it on a hanger, such as my Triple Ring Hanger or an official hanger for at least 10 minutes before connecting it to the fan dryer.** This design is intended to be compatible with most DVR/Modem cooling fans you can find on amazon/google shopping. Example: [here](https://www.amazon.com/Neukniy-Computer-Controller-Playstation-Receiver/dp/B0BV7DW9CS) or [here](https://www.amazon.com/WDERAIR-Multi-Speed-Controller-Playstation-Electronics/dp/B0CD9R8YTG) Print upside down so that the top is flush with the print bed, doing so should let you print without supports.