Double Bell Kar98k/Lee Enfield Shell + BB remover Tool

INSTRUCTIONS Print at 100% infill with any standard PLA. Does not require supports, but I typically print it with Rafts. You will need a 4x1mm O-ring to seal the rear of the shell with the bolt of the gun. The BB is retained by the shell itself. LINK TO O-RING: https://www.oringsandmore.com/metric-buna-o-rings-4-x-1-2mm-minimum-25-pcs/ The rim is the main weak point of the shell. I use floor gloss to cover the rear of the shell to enhance durability, and then glued the O-ring in with a small amount of super glue applied to where it seats. The O-rings rarely fall out of the shell, but I ended up gluing mine after one fell out after hard use. Clean your shells with soap and water after use in the field. If a shell is dirty, do not reuse until clean as you can gum up your action. I used these in a game and had an absolute blast! Ending a "Defend the Bunker" scenario with 40+ shells surrounding me was a whole different airsoft experience. Of the 60 shells I had that day, I didn't lose