Ender 3 S1 Pro ADXL345 Accelerometer Sensor 2-in-1 Extruder / Bed Mount for Klipper Input Shaping

A 2-in-1 ADXL345 mount that attaches to the extruder for the x-axis and clips onto the bed for the y-axis. When done running input shaper, just unplug your cable and leave the mount attached to the extruder or remove it and stick it in the storage drawer. More Ender 3 S1 models at https://www.thingiverse.com/vampyrex13/collections/my-ender-3-s1-pro-models. Klipper Firmware Notes ---------------------- Here's my recommended config settings to use for this mount. It has the axis corrected for the positioning of the sensor. Just run use the SHAPER_CALIBRATE_HOTEND macro for the extruder and SHAPER_CALIBRATE_BED for the bed. [mcu rpi] serial: /tmp/klipper_host_mcu [adxl345 hotend] cs_pin: rpi:None axes_map: -y, x, z [adxl345 bed] cs_pin: rpi:None axes_map: x, y, z [resonance_tester] accel_chip_x: adxl345 hotend accel_chip_y: adxl345 bed probe_points: 112.5, 112.5, 20 [input_shaper] [gcode_macro SHAPER_CALIBRATE_HOTEND] description: Measure hotend resona