RapidMag Heavy - Nerf MEGA 20x95mm Magazine 10 and 17 round capacity

#RapidMag Heavy A printable 20mm MEGA magazine for hobby grade nerf blasters, especially designed for full auto or high ROF use. Intended to fit standard ~250mm (X) i3 beds. Features: Rail-guided tall follower for tilt resistance. Side reliefs and front sharp guide rail to prevent rubber tip scrubbing and wedging. Toolpath control texture on inside surfaces that contact darts, as necessary to present only extrusions parallel to feed direction. Printing: Don't field PLA! Recommended (for 0.45-ish mm extrusion width): 3 perimeters, 20% hex infill, 6 tops/bottoms. Orientations: All body pieces outside surface on the bed. Follower standing on the bottom surface. HARDWARE: 6-32 x 0.5" SHCS for body assembly x 11 (10 round monolithic) or x 15 (extended 17 round) One 6-32 x 1.5" SHCS for the spring pulley shaft in the follower. One constant force nerf drum mag spring, available from various hobby suppliers. ** It may be possible to substitute M3 SHCS for 6-32 - do not dr