Hellraiser Lament Configuration Jewellery Box Remix

I started with Imirnman's Hellraiser Jewellry Box, but cut it up so that each side would print facing up, for slightly better detail quality. I used an Up Plus2 on Fine detail with Thin Wall setting enabled (important). Gluing it back together was fairly tricky. I had to tidy up the edges with a sharp knife to get it all to fit (my alignment notches didn't work very well) and then I used a lot of elastic bands to hold it while the glue dried. I sanded the sides for flatness after printing, then used gloss gold-coloured spray paint, sprayed lightly onto a flat piece of wood, then pressed the box sides onto the wood to pick up paint a bit at a time. If the paint is too wet, it will flow into the holes in the design. If you paint the sides before gluing, you have a chance to reprint any that get ruined by too much paint. It can be hard to hold the sides while painting if you do it this way - some blu-tac may help. I recommend you use the drawers from Imirnman's design.